Dunlop Collection

Roughout Rectangular cross-section at bevel, irregular trapezoid cross-section at blade with back narrower than the front rough flaked surface, and smooth unworked stone surface on back There is a narrowing and then widening of the sides of the blade towards the poll The stone at the lower back of the adze slopes down to the bottom edge but it ends at a blunt irregular edge rather than a sharp cutting edge. The blade is asymmetrical and unfinished. Sharp irregular ridges form the narrower back side of the blade, widest at bevel, waisted near the top and wide again at the poll

Roughout Asymmetrical cross-section Flaked surface Blade tapers in from the bottom edge towards the poll The piece is so roughly cut that it is unclear which is the front or back. The cutting edge is undefined, irregular and asymmetrical

Complete curved bone pendant. Reduced with suspension hole at the proximal end. Rounded at the distal end.

Complete composite fishhook. Wooden shank carved with double-sided faces at the head, one at the base and one below the point and other geometric shapes throughout. Curved bone point with two internal and two external barbs and two internal notches, lashed to the shank with twisted muka. Two knobs at the head with twisted muka lashings and a plaited cord projecting from the top.

Broken pipe, bowl and part of stem remaining. Bowl is deep. Proper left side is darker than proper right side, probably where fire was put to the bowl for lighting. There is a small knob on the lower side of the pipe where the bowl meets the stem. There is a fine perforation running through the stem.

Stone tool, use unknown. Convex shape, tapered to a point at each end. Surface is ground on the edges of the points but rough everywhere else.

Broken totara tauihu (prow) of waka taua (war canoe). All carving are worn, especially on the proper right. Fretwork carving of two spirals on body, top of spirals broken off. Large human face protruding forwards, tongue protruding with the top half of the face missing. There is piko-o-rauru (double spiral) carving on the cheeks and worn carving on the lips and tongue. The face has been reattached using three metal pins. A full figure lies horizontal at the base of the two vertical spirals, split in two by the spirals. A third face is carved at the rear of the prow. There is worn tuara-kuri (diamond notches) carving on the prow. The proper right lashing board is broken off, with the front-most lashing hole remaining. The proper left lashing board has four drilled holes remaining.

Complete unfinished adze. Dark brown stone. Quadrangular cross-section. The surface is bruised and ground. There is no distinction between the butt and the blade apart from a little bruising around the butt. The bevel is smooth and continuous with the blade. The cutting edge is curved and asymmetrical.

Complete adze Trapezoidal cross-section. Front of blade has slight bruising and flake scars with bottom portion slightly ground. Back of blade also has some bruising, flake scars and grounding. Undifferentiated between blade and butt. Bevel is continuous with the blade and is slightly curved with cutting edge appearing sharp.

Complete sinker with shallow transverse lashing groove.